Jump to content
forum.electromaniacs.com

Whirlpool Appliances

Sign in to follow this  

Whirlpool Appliances manuals

3 files

  1. Whirlpool microwave AVM510

    Whirlpool microwave AVM510 Ver853851053221

    Introduction safety
    INTRODUCTION
    Before leaving the factory each oven is carefully checked.
    It must, however, be installed and used correctly.
    Despite all the steps taken to make the oven safe, the safety is dependent on the correct installation and the fact
    the user understands how to use and maintain the oven.
    The information in this section should be used as a reminder that the oven is safe and that anyone who uses it must
    first read the instructions for use in order to be able to use the oven correctly and obtain best results.
    SAFETY
    To avoid injury to yourself and damage to the appliance always work to the following rules when servicing an oven.
    Always disconnect the plug from the mains before starting work.
    If there is no plug switch off the electric supply at the control box.
    When you have finished servicing an oven before you reconnect it to the mains, make sure that:
    - all the internal connections are correct
    - the wires are insulated and not touching the door or the cabinet or anything sharp
    - all the earth connections are electrically and mechanically sound
    - do not modify or anyway interfere with the safety devices built-in to the oven
    - make sure that each replacement part you use conforms to the manufacturer´s specifications
    Do not start a repair if you have any doubt as to your ability to complete it.

    CAUTION - MICROWAVE RADIATION
    PERSONNEL SHOULD NOT BE EXPOSED TO THE MICROWAVE ENERGY WHICH MAY RADIATE FROM THE MAGNETRON,
    WAVEGUIDE OR ANTENNA IF THEY ARE IMPROPERLY USED OR CONNECTED. ALL INPUT
    AND OUTPUT MICROWAVE CONNECTIONS, WAVEGUIDES, FLANGES AND GASKETS MUST BE SECURE.
    NEVER OPERATE THE DEVICE WITHOUT A MICROWAVE ENERGY ABSORBING LOAD ATTACHED.
    NEVER LOOK INTO AN OPEN WAVEGUIDE OR ANTENNA WHILE THE DEVICE IS ENERGIZED.
    NEVER OPERATE AN OVEN WITH CABINET OFF WITHOUT MEASURING THE MICROWAVE LEAKAGE
    AROUND MAGNETRON AND VISIBLE MICROWAVE CONNECTIONS (WELDING JOINTS).
    Do not operate the oven if the following conditions exist:
    - the door does not close firmly against the door support because of the door being warped or the hinges damaged.
    - The door trims or seals are damaged.
    - If there is any visible damage to the oven.
    - if the door does not close properly.
    Avoid operating the oven if known components in the interlock system, oven door or microwave
    generating assembly are known defective. They must be replaced.
    WARNING - HIGH VOLTAGE
    IT IS POSSIBLE TO COME IN CONTACT WITH LETHAL HIGH VOLTAGE WHEN WORKING WITH
    HV TRANSFORMER, HV CAPACITOR AND MAGNETRON. THEREFORE NEVER TRY TO MEASURE
    THE HIGH VOLTAGE. ALWAYS TAKE UTMOST CARE WHEN PERFORMING ELECTRIC
    MEASUREMENTS INSIDE THE OVEN.

    42 downloads

    Submitted

  2. AVM 585 Service Manual Microwave oven

    Service Manual
    Microwave oven
    Model AVM 585 Version 8538 585 53211

    Introduction safety
    INTRODUCTION
    Before leaving the factory each oven is carefully checked.
    It must, however, be installed and used correctly.
    Despite all the steps taken to make the oven safe, the safety is dependent on the correct installation and the fact
    the user understands how to use and maintain the oven.
    The information in this section should be used as a reminder that the oven is safe and that anyone who uses it must
    first read the instructions for use in order to be able to use the oven correctly and obtain best results.
    SAFETY
    To avoid injury to yourself and damage to the appliance always work to the following rules when servicing an oven.
    Always disconnect the plug from the mains before starting work.
    If there is no plug switch off the electric supply at the control box.
    When you have finished servicing an oven before you reconnect it to the mains, make sure that:
    - all the internal connections are correct
    - the wires are insulated and not touching the door or the cabinet or anything sharp
    - all the earth connections are electrically and mechanically sound
    - do not modify or anyway interfere with the safety devices built-in to the oven
    - make sure that each replacement part you use conforms to the manufacturer´s specifications
    Do not start a repair if you have any doubt as to your ability to complete it.
    CAUTION - MICROWAVE RADIATION
    PERSONNEL SHOULD NOT BE EXPOSED TO THE MICROWAVE ENERGY WHICH MAY RADIATE FROM THE MAGNETRON,
    WAVEGUIDE OR ANTENNA IF THEY ARE IMPROPERLY USED OR CONNECTED. ALL INPUT
    AND OUTPUT MICROWAVE CONNECTIONS, WAVEGUIDES, FLANGES AND GASKETS MUST BE SECURE.
    NEVER OPERATE THE DEVICE WITHOUT A MICROWAVE ENERGY ABSORBING LOAD ATTACHED.
    NEVER LOOK INTO AN OPEN WAVEGUIDE OR ANTENNA WHILE THE DEVICE IS ENERGIZED.
    NEVER OPERATE AN OVEN WITH CABINET OFF WITHOUT MEASURING THE MICROWAVE LEAKAGE
    AROUND MAGNETRON AND VISIBLE MICROWAVE CONNECTIONS (WELDING JOINTS).
    Do not operate the oven if the following conditions exist:
    - the door does not close firmly against the door support because of the door being warped or the hinges damaged.
    - The door trims or seals are damaged.
    - If there is any visible damage to the oven.
    - if the door does not close properly.
    Avoid operating the oven if known components in the interlock system, oven door or microwave
    generating assembly are known defective. They must be replaced.
    WARNING - HIGH VOLTAGE
    IT IS POSSIBLE TO COME IN CONTACT WITH LETHAL HIGH VOLTAGE WHEN WORKING WITH
    HV TRANSFORMER, HV CAPACITOR AND MAGNETRON. THEREFORE NEVER TRY TO MEASURE
    THE HIGH VOLTAGE. ALWAYS TAKE UTMOST CARE WHEN PERFORMING ELECTRIC
    MEASUREMENTS INSIDE THE OVEN.

    44 downloads

    Submitted

  3. MICROWAVE OVEN Model AVM595 WH

    SERVICE MANUAL
    MICROWAVE OVEN
    Model AVM595 WH
    Version 8538 595 53291
    Model AVM595 BL
    Version 8538 595 53491

    SAFETY PRECAUTIONS

    Before leaving the factory each oven is carefully checked. It must however, be installed and used
    correctly.
    Despite all the steps taken to make the oven safe, the safety is dependent on the correct installation and
    the fact the user understands how to use and maintain the oven.
    The information in this section should be used as a reminder that the oven is safe and that anyone who
    uses it must first read the instructions for use in order to be able to use the oven correctly and obtain best
    results.
    SAFETY
    To avoid injury to yourself and damage to the appliance always work to the following rules when servicing
    an oven.
    Always disconnect the plug from the mains before starting work.
    If there is no plug, switch off the electrical supply at the control box.
    When you have finished servicing an oven and before you reconnect it to the mains make sure
    that:
    • all the internal connections are correct
    • the wires are insulated and not touching the door or the cabinet or anything sharp
    • all the earth connections are electrically and mechanical sound
    • do not modify or anyway interfere with the safety devices built-in to the oven
    • make sure that each replacement part you use conforms to the manufacturer’s
    specifications.
    Do not start a repair if you have any doubt as to your ability to complete it.
    CAUTION - MICROWAVE RADIATION
    PERSONNEL SHOULD NOT BE EXPOSED TO THE MICROWAVE ENERGY WHICH MAY RADIATE
    FROM THE MAGNETRON, WAVEGUIDE OR ANTENNA IF THEY ARE IMPROPERLY USED OR
    CONNECTED. ALL INPUT AND OUTPUT MICROWAVE CONNECTIONS, WAVEGUIDES, FLANGES
    AND GASKETS MUST BE SECURE. NEVER OPERATE THE DEVICE WITHOUT A MICROWAVE
    ENERGY ABSORBING LOAD ATTACHED. NEVER LOOK INTO AN OPEN WAVEGUIDE OR
    ANTENNA WHILE THE DEVICE IS ENERGISED. NEVER OPERATE AN OVEN WITH THE CABINET
    OFF WITHOUT MEASURING THE MICROWAVE LEAKAGE AROUND MAGNETRON AND VISIBLE
    MICROWAVE CONNECTIONS (WELDING JOINTS.)
    Do not operate the oven if the following conditions exist:
    - the door does not close firmly against the door support because of the door being
    warped or the hinges damaged.
    - the door trims or seals are damaged
    - if there are any visible damage to the oven
    - if the door does not close properly
    Avoid operating the oven if known components in the interlock system, oven door or microwave
    generating assembly are known defective. They must be replaced.
    WARNING - HIGH VOLTAGE
    IT IS POSSIBLE TO COME IN CONTACT WITH LETHAL HIGH VOLTAGE WHEN WORKING WITH HV
    TRANSFORMER, HV CAPACITOR AND MAGNETRON. THEREFORE NEVER TRY TO MEASURE
    THE HIGH VOLTAGE. ALWAYS TAKE UTMOST CARE WHEN PERFORMING ELECTRICAL
    MEASUREMENTS INSIDE THE OVEN.

    59 downloads

    Submitted

Sign in to follow this  
×